Dongguan manufacturing
Our Dongguan facility runs controlled twin-screw extrusion and pelletizing under a documented total quality management system. Every batch is tested and traced before it leaves the plant.
Quality control stages
Core test families
Quality assurance
01
Incoming resins and additives are checked against specification before they enter production, so off-spec feedstock never reaches the compounding line.
02
Twin-screw extrusion and pelletizing parameters are logged for every run, keeping melt conditions consistent from batch to batch.
03
Samples are tested for melt flow rate, tensile strength, and impact resistance against the target grade before release.
04
A quality reviewer confirms results and issues a certificate of analysis that travels with every shipment.
Laboratory equipment
Our laboratory uses calibrated instruments to measure the properties buyers depend on.
Flow behavior
Measure melt flow rate to confirm that each batch processes consistently in the customer's molding or extrusion equipment.
Mechanical strength
Record tensile strength and elongation so mechanical performance can be compared directly against the grade specification.
Colour accuracy
Quantify colour against the approved standard so compounds match the target shade from one production run to the next.
Notifications